Unpacking And Installing The Mcc-Ps - Cabletron Systems MCC-16 User Manual

INSTALLATION

2.4 UNPACKING AND INSTALLING THE MCC-PS

A single MCC-PS can power any possible configuration; however, two
are required to provide redundancy. (Refer to
MCC-PS specifications.)
To unpack an MCC-PS:
Remove the MCC-PS from the protective bag and place it on top of the
1.
bag in a dry, static-free, dust-free area.
Remove the power cord included with the MCC-PS.
2.
Save the box and packaging materials for possible future repackaging
and shipment.
Inspect the shipment for any signs of damage.
3.
Install an MCC-PS into the MCC-16 as follows:
Fully insert the power supply into the MCC-16, as shown in
1.
Figure 2-3, and turn the fastening knob.
Figure 2-3 Inserting The Power Supply Into The MCC-16
To install the second MCC-PS unfasten the screw located along the
2.
back side of the MCC-16 and remove the back cover, as shown in
Figure 2-4.
Fully insert the second MCC-PS and secure it with the fastening knob.
3.
2-4
POWER 2
Section A.3
POWER 1
for exact
MCC-PS
POWER IN
POWER OUT
OVERLOAD
100-125V - 4.0A
FAN 200-250V - 2.0A
50/60Hz
SN