Turning The Mcc-16 On And Off; Unpacking A Cm - Cabletron Systems MCC-16 User Manual

INSTALLATION

2.4.2 Turning The MCC-16 On And Off

You turn on the MCC-16 by connecting it to a power source, and you turn
it off by disconnecting it from the power source. Use the power cord
included with the MCC-PS. Connect the cord to or disconnect it from an
AC power source, as shown in
To connect to a power source and turn on the MCC-16:
Attach the power cord's female connector to the male power source
1.
connector on the MCC-PS.
Plug the power cord's male connector into a grounded power outlet.
2.
To turn off the MCC-16:
Disconnect the power cord from the power outlet.
Figure 2-5 Connecting The MCC-16 To A Power Source

2.5 UNPACKING A CM

Electrostatic Discharge (ESD) can damage a CM. To prevent
!
ESD damage when handling a CM:
• Wear the grounding wriststrap.
CAUTION
• Hold only the edges of the CM or the metal front panel.
• Avoid touching the CM components.
2-6
Figure 2-5.
POWER 2
POWER 1
MCC-PS
POWER IN
POWER OUT
OVERLOAD
100-125V - 4.0A
FAN
200-250V - 2.0A
50/60Hz
SN