Table of Contents
Advertisement
4.2 CONFIGURING THE MCC-DFL
Refer to
Figure 4-3
when configuring the MCC-DFL. The switches shown in
in their On or Off positions as set at the factory (default settings). You
may change the switches for the applications described in
through
Section
The SW1 switchblock controls FOT-A. The SW2 switchblock
NOTES
controls FOT-B. Individual switches on each switchblock have
the same functionality.
Jumper P1 controls the ring speed of FOT-A. Jumper P2
controls the ring speed of FOT-B.
SW1
SW2
Figure 4-3 Location of SW1/SW2 Switchblocks And Jumpers P1/P2
through
Figure 4-7
4.2.4.
SW1
P1
P2
SW2
(Default Settings)
and
Table 4-1
P1
P2
Switch Configuration Table
(From back of card)
SW1 (FOT-A or RI)
SW2 (FOT-B or RO)
On – Cabletron fiber key
1
Off – 802.5J fiber key
On – RO or lobe (RJ45 port)
2
Off – RI or station (RJ45 port)
On – Autowrap enable (RJ45 port)
3
Off – Autowrap disable (RJ45 port)
On – Station and lobe application
4
Off – RI and RO application
MCC-DFL SETUP
through
Table 4-4
Figure 4-3
are
Section 4.2.1
4-3
Advertisement
Table of Contents
