Configuring The Rj45 Port As Ri And The Fiber St Port As Ro - Cabletron Systems MCC-16 User Manual

MCC-DFL SETUP
4.2.3 Configuring The RJ45 Port As RI
And The Fiber ST Port As RO
Do not use RI/RO ports to connect rings that are intended to be
NOTE
physically separate segments. Using RI/RO ports to join
separate rings will create one ring. This configuration functions
but may cause the new ring to exceed the maximum station
count, depending on the size of the originally separate rings.
You can configure the RJ45 port as a RI and the fiber ST port as a RO
(see Figure 4-6) by setting the switches as shown in
MMAC
4-6
Ring Out To Ring In
Ring Out To Ring In
Figure 4-6 RJ45 RI And Fiber ST RO
MCC-DFL
PWR P1
P2
16 Mb
P
1
F
O
T TX
A
Ring Out To Ring In
P
2
RX
PWR P1
P2
16 Mb
TX
Ring Out To Ring In
P
1
F
O
RX
T
B
P
2
Table 4-3.
MMAC