Switch 4 - Cabletron Systems MCC-16 User Manual

MCC-DFL SETUP
4.4.3 Switch 3
When the FOT is being used as a RI/RO device this switch enables or
disables the autowrap feature on the RJ45 port. The feature should be
enabled to connect to Cabletron devices or disabled to connect to 802.5
compliant devices. Set Switch 3 as shown in
Table 4-9 Setting For Switch 3 (SW1 And SW2 Switchblocks)
Autowrap on RJ45 RI/RO Port
Connection to Cabletron devices
Connection to 802.5 compliant devices

4.4.4 Switch 4

This switch selects the mode on the entire FOT. Use the switch to
configure it as a RI/RO device or a station/lobe device. Then use Switch 2
to establish the configuration of the RJ45 port; the fiber ST port
configures automatically. Set Switch 4 as shown in
Table 4-10 Settings For Switch 4 (SW1 And SW2 Switchblocks)
Configure FOT Mode for
RI/RO applications
Station/Lobe applications
4-10
Table 4-9.
Set Switch 3 to Position
On
Off
Table
)
Set Switch 4 to Position
Off
On
4-10.