Table of Contents
Advertisement
INSTALLATION
Fully insert the CM into the MCC-16 by sliding the CM into the top
2.
and bottom board slots in the MCC-16, as shown in
The PWR LED lights indicating the reception of power.
Never use more than the minimal amount of physical force
!
necessary to insert a CM into the MCC-16. If you feel any
resistance while inserting, STOP! Remove the CM and inspect
CAUTION
the slot and the CM for obstructions or structural irregularities.
If you detect damaged components, call Cabletron Systems
Global Call Center for assistance.
3.
Tighten the screw at the top of the CM with a flat-head screwdriver.
2-8
Figure 2-6 Removing A Protection Panel
Figure 2-7 Inserting A CM Into The MCC-16
MCC-16
MCC-16
MCC-DFL
Figure
2-7.
Advertisement
Table of Contents
