Table of Contents
Advertisement
This chapter covers the required tools and instructions for installing the
EMC39-12 on a shelf or into a standard rack, unpacking the device, and
connecting it to the power source.
2.1
REQUIRED TOOLS
A Phillips screwdriver is required to install the equipment.
2.2
UNPACKING THE EMC39-12
To unpack the shipment, proceed as follows:
1. Carefully remove the EMC39-12 from the shipping box. Save all
shipping material in case any items need to be returned.
2. Visually inspect the EMC39-12 and any optional equipment.
3. Remove the EMC39-12 from its non-conductive bag. If there are any
signs of damage, contact Cabletron Systems Technical Support. Refer
to Section 1.7, Getting Help, for details.
2.3 INSTALLING THE EMC39-12
Do not remove the cover from the EMC39-12. There are no
!
user configurable devices inside and the electronics are static
CAUTION
sensitive.
The EMC39-12 may be installed on a tabletop, shelf, or in a 19-inch rack.
Refer to Section 2.3.1 for information concerning a tabletop or shelf
installation. Section 2.3.2 describes the rackmount installation.
EMC39-12 User's Guide
CHAPTER 2
INSTALLATION
2-1
Advertisement
Table of Contents
