Replicator 2X Shakes - MakerBot Replicator 2X Troubleshooting And Maintenance

PRINTING ISSUES

REPLICATOR 2X SHAKES

Your Replicator 2X will shake during printing
if you print at high speeds with acceleration
turned off. Attempting to print at high
speeds with acceleration turned off can
harm your MakerBot Replicator 2X.
To check and change the Acceleration
setting, go to the LCD menu on your
CONTINUED
Replicator MakerBot 2X and navigate to
Info and Settings > General Settings >
Accelerate. You can turn acceleration off and
on. You can also do this using the Onboard
Preferences in MakerWare or ReplicatorG.
Acceleration is turned on by default. If you
have acceleration turned off, you should not
print at speeds above 40 mm/s.
TROUBLESHOOTING 7