MakerBot Replicator 2X Troubleshooting And Maintenance page 25

DIAGNOSING PRINT QUALITY ISSUES
File Name: 3D mouse
Design by: DDStarkey
Thingiverse: 61909
File Name: 3D mouse
Design by: DDStarkey
Thingiverse: 31909
If you are overextruding [Fig. 1.6], increase the
"feedstockMultiplier" setting by 0.05, save
the config file, and Export your file again. If the
"feedstockMultiplier" setting reaches a value
of 1.0 without the problem being resolved, you
might have a different issue. Please contact
MakerBot Support.
If you are underextruding [Fig. 1.7], decrease
the "feedstockMultiplier" setting by 0.05,
save the config file, and Export your file
again. Continue to decrease the value
entered for this setting in increments. If,
after lowering the default setting by a total
Fig. 1.6
of 0.2, your results do not improve, you
might have a different issue. Please contact
MakerBot Support.
Fig. 1.7
CONTINUED
TROUBLESHOOTING 25