MakerBot Replicator 2X Troubleshooting And Maintenance page 17

MAKERBOT MAKERWARE ERROR MESSAGES
MAKERWARE WINDOW
The following error messages could appear in the main MakerWare window during operation:
Error Message
Print failed.
See MakerWare log for more information.
Service Error.
No connection to the background service.
There are unfinished exports in progress.
Closing MakerWare will prevent these files
from being placed in the correct directory.
Error Saving [file name and location].
Unable to open file for writing.
Description
This error message appears when:
• A print is cancelled before completion.
• The MakerBot Replicator 2X is
disconnected from the computer where
MakerWare is running during a print via
USB. Check the USB connection between
the MakerBot Replicator 2X and the
computer.
• Conveyor, the background service, is
unavailable. To restart Conveyor, go to
the Service menu and select "Restart
Background Service."
This error message appears when:
• You try to print an object while the
background is unavailable.
• You try to export a file while the
background service is unavailable.
To restart Conveyor, the background service:
1. Go the Services menu.
2. Select Restart Background Service.
• Select Cancel to keep MakerWare open
and running until the export completes.
You can then quit MakerWare again.
• Select Close MakerWare to close
MakerWare without finishing the export.
This message appears when you try to save
a file to a location that is read-only.
Try saving to another location.
TROUBLESHOOTING
CONTINUED
17