Loading System Image Software - Cabletron Systems SmartSwitch 6000 Installation & User Manual

Loading System Image Software

6. Enter the show command to show the commands you just entered. Because you have not
activated these configuration changes yet, they are listed in the scratchpad section of the output.
Here is an example:
ssr
-1(config)#
Running system configuration:
!
! Last modified from Console on Mon Jan 19 12:37:21 1998
!
1 : interface add ip en0 address-netmask 10.50.11.22/16
!
2 : system set dns server 10.50.11.12
3 : system set dns domain mktg.cabletron.com
4 : system set name "ctron-ssr-1"
5 : system set location "Sunnyvale, CA
6 : system set contact "John Smith"
7 : system set hashed-password login jNIssH c976b667e681d03ccd5fc527f219351a
8 : system set hashed-password enable zcGzbO 5d1f73d2d478ceaa062a0b5e0168f46a
!
9 : snmp set community public privilege read
10 : snmp set target 10.50.11.12 community public
******** Non-committed changes in Scratchpad ********
1*: system set syslog server 10.50.11.12
2*: system set syslog level info
3*: system set syslog facility local0
The other configuration changes made during this CLI session are also listed. Active
Note:
changes are listed in the "Running system configuration section" and unactivated
changes are listed in the "Non-committed changes in Scratchpad" section.
7. To activate the SYSLOG commands, enter the save active command.
Loading System Image Software
The 6SSRM-02 operates using the system image software installed in its internal flash chip. To
upgrade the system software and operate using the upgraded image, go through the following
procedure:
3-14 Software Installation and Setup
show