Unpacking The Module; Installing The Line Cards - Cabletron Systems SmartSwitch 6000 Installation & User Manual

Unpacking the Module

Unpacking the Module
Unpack the module as follows:
1. Open the box and remove the packing material protecting the 6SSRM-02.
2. Verify the contents of the carton as listed in
3. Remove the tape seal on the non-conductive bag to remove the 6SSRM-02.
4. Perform a visual inspection of the module for any signs of physical damage. Contact Cabletron
Systems if there are any signs of damage.

Installing the Line Cards

Two Line Cards can be installed in the 6SSRM-02 module. They must be installed before the
6SSRM-02 module is installed into the 6C105 chassis. The Line Cards are shipped with
installation instructions. Refer to these instructions before installing.
Note: Due to a power restriction with the SS6000, the 6SSRM-02 can only support one linecard
when either 6SSRLC-FX or 6SSRLC-TX is installed. Any other combination of two linecards is fully
supported in the SS6000.
2-2 Installation
Table 2-1 Contents of 6SSRM-02 Carton
Item
6SSRM-02
Antistatic Wrist Strap
Manual Accessory Kit
Table 2-1.
Quantity
1
1
1