Lcm Commands - Cabletron Systems SmartSTACK 10 ELS10-26 Getting Started

LCM Commands

addresses display
Displays learned addresses.
Options:
any
ADDRESS
MASK
Example: address display any
arp display
Displays the ARP table.
Example: arp display
Enter
baud
Displays the current baud rate of your LCM console connection,
and allows you to change the baud rate.
Options:
200
2400
4800
9600
19200
Example: baud 9600
Enter
bridge
Displays the bridging status for all ports, and allows you to set
bridging options for a single port or a range of ports.
Options:
off
on
no
BPDU
Example: bridge 2-6 on
Enter
clearstats
Allows you to clear statistics on all ports.
Example: clearstats
Enter
Enter
community
Allows you to assign a new community name or change an existing one.
Example: community
date
Allows you to display or set system date.
Option:
MMDDYY
Example: date 051897
disable
Allows you to disable a port or range of ports.
Example: disable 7-9
duplex
Allows you to display or set the duplex mode for a port or range of ports.
Options:
auto
half
full
Example: duplex 7-9 full
enable
Allows you to enable a port or range of ports.
Option:
no
RIP
TransmitPacing
Example: enable 7
Enter
erase
Allows you to erase all configuration information on the next system reset. You
are prompted to confirm this action.
Example: erase
Enter
– 9 –
Enter
Enter
Enter
Enter