Operational Controls; Height Adjustment Handles; Primary Sdla Control Lever; Secondary Sdla Control Lever - Ventrac MY560 Operator's Manual

OPERATIONAL CONTROLS

Height Adjustment Handles

A
A
The height adjustment handles (A) are used to raise
and lower the mower deck to the desired cutting
height. The right and left adjustment handles must
both be set to the same height position. The cutting
height position decals list the adjustment handle posi-
tions and the corresponding cutting heights.

Primary SDLA Control Lever

Pull the power unit's primary SDLA control lever* to
the left to raise the power unit front hitch and the flail
mower. Push the lever to the right to lower the power
unit front hitch and the flail mower. When mowing,
place the control lever in the float position by pushing
the lever to the right until the float detent locks the
lever in place.

Secondary SDLA Control Lever

The power unit's secondary SDLA control lever* con-
trols the optional hydraulic deck flip up kit. Pull the
lever to the left to flip the deck up to the service posi-
tion. Push the lever to the right to lower the deck back
down to the operating position.

Weight Transfer

Terrain and ground conditions may affect the appro-
priate setting for the power unit's weight transfer sys-
tem*. In most cases, the weight transfer system should
be set from three-fourths to full capacity.
*Refer to power unit operator's manual for operation of power unit controls.
Operation - 16