Operational Controls; Operational Control Locations; Main Belt Tensioner (A); Height Adjustment Handle (B) - Ventrac LM600 Operator's Manual & Parts

Operational Control Locations

Use the following images to help identify the locations
of operational controls. The letter next to each control
can be referenced to the list that follows these images.
A - Main Belt Tensioner
B - Height Adjustment Handle

Main Belt Tensioner (A)

Release
tension
Rotating the main belt tensioner clockwise until it
locks applies tension to the attachment drive belt.
Rotating the main belt tensioner counter-clockwise
releases tension on the attachment drive belt, allow-
ing the operator to remove or install the attachment
drive belt onto the power unit.

OPERATIONAL CONTROLS

OPERATIONAL CONTROLS
A
B
Apply
tension
Operation - 15

Height Adjustment Handle (B)

The height adjustment handle is used to raise or
lower the deck to achieve the desired cutting height.