Operational Controls; Height Adjustment Handle; Primary S.d.l.a. Control Lever; Weight Transfer - Ventrac HM602 Operator's Manual & Parts Drawings

Height Adjustment Handle

The height adjustment handle (A) is used to raise or
lower the mower deck and to lock the mower deck at
the desired cutting height.

Primary S.D.L.A. Control Lever

Pull the primary S.D.L.A. lever to the left to raise the
power unit front hitch and mower deck. Push the
lever to the right to lower the power unit front hitch
and mower deck. The control lever must be in the
float (detent) position during operation of the mower.
Float position is attained by pushing the lever to the
right until the float detent locks the lever in place.
*

Weight Transfer

Terrain and ground conditions may affect the appro-
priate setting for the power unit's weight transfer
system. In most cases, the weight transfer system
should be set from 1/2 to 3/4 of maximum capacity.

OPERATIONAL CONTROLS

A
*
Operation - 15
* Refer to power unit operator's manual for operation of
power unit controls.