Lighting Instructions - DCS THE PROFESSIONAL LIBERTY COLLECTION BFGC-30 Series Installation Manual

Table of Contents

Available languages

USING THE GRIDDLE

LIGHTING INSTRUCTIONS

Push in and turn griddle control knob to "HI" position. Pushing control knob in activates the ignition module and

produces repeated sparking at burner igniter. Holding control knob in also opens the integral safety valve used

for this section and starts the flow of gas to burner. Once burner is lit, continue to hold in the control knob for 10

seconds, or until burner remains lit after control knob is released. The knob can then be turned to desired posi-

tion.

MATCH LIGHTING

Insert a paper book match (DO NOT LIGHT) securely into the clip end of the match extension rod. Light the match

held on the end of the rod and hold up against the bottom of the flash tube on the left side of the flue cover (Fig.

57). Push, turn and hold the griddle control knob to "HI". Once burner is lit, continue to hold in the control knob

for 10 seconds, or until burner remains lit after control knob is released. The knob can then be turned to desired

position. If the burner does not light after 4 seconds, turn the knob "OFF". Wait 5 minutes for any accumulated gas

to dissipate before trying to light the burner again.

Fig. 57

Table of Contents

Table of Contents