Table of Contents
Advertisement
Lighting Instructions
Grill lighting instructions
IMPORTANT!
•
Open the grill hood before lighting. Turn all knobs to "OFF". Turn the main gas supply on. If you
smell gas, shut-off gas supply and call for customer care. Only light one burner at a time.
Pushing in on the burner knob will activate the Grill Igniter, and then turning the knob from the "OFF"
position will allow the flow of gas to the burner.
The Grill Igniter will glow orange, but there will be no clicking sound during ignition. Push in and hold
the burner knob for two seconds. Verify that the hot surface ignitor is glowing. Turn the knob
counterclockwise. Release when the burner lights. If the burner does not light in four to five seconds,
turn knob "OFF" and wait five minutes before trying again so any accumulated gas may dissipate.
Match lighting
If the burner will not light after several attempts, then
the burner can be match lit. If you have attempted to
light the burner with the ignition, allow five minutes for
any accumulated gas to dissipate.
U-burners
Keep your face as far away from the grill as possible
while manually igniting. To manually ignite, light a butane
lighter before pushing and turning the control knob
to "SEAR" for the leftmost or rightmost burner. Wait
2 seconds for gas to prime manual ignition tube, then
move lighter to 10mm in front and a little below the hole
located to the left of the burner (Fig. 16a). If the burner
does not light in four to five seconds, turn knob off, wait
five minutes and try again.
Sear burner (some models only)
Keep your face as far away from the grill as possible. To
light, place a lit butane lighter into the gap between the
grates until the lighter touches the mesh. (Fig.16b). Push
and turn the knob to "MAX". If the burner does not light in
four to five seconds, turn knob off, wait five minutes and
try again.
Refer to the Troubleshooting section of the user guide if you encounter any difficulties lighting your grill.
See the Quick Start Guide for how to use the griddle and Infrared Hybrid Burner.
Resetting the flow control
IMPORTANT!
Failure to follow the steps in the order shown may cause the Flow Limiting Device to activate resulting
in extremely low gas flow and irregular operation
Improper lighting procedures can cause the LP tank flow control to activate resulting in reduced heat
output. If this is suspected the flow control will need to be reset.
1 All knobs must be in the
OFF position.
24
USING THE GRILL
2 Attach regulator hose
assembly to the tank.
FIG. 16a
FIG. 16b
3 Open the LP tank valve.
(Two full turns min).
Advertisement
Table of Contents
