Using The Grill Lighting Instructions - DCS 30” BGB Series Installation Instructions And User Manual

USING THE GRILL
LIGHTING INSTRUCTIONS
TO LIGHT THE GRILL BURNER:
Open the grill lid before lighting. Turn all knobs to "OFF". Turn the main gas supply on slowly. If you smell gas, shut-off
gas supply and call for service.
Push and hold the ignition button, turn the selected burner knob to "SEAR". If burner does not light in 4 to 5 sec-
onds, turn knob "OFF" and wait 5 minutes before trying again for any accumulated gas to dissipate.
Grill Match Lighting:
If the burner will not light after several attempts then the burner can be match lit. If you've just attempted to
light the burner with the ignition, allow 5 minutes for any accumulated gas to dissipate. Keep your face as far
away from the grill as possible and hold and pass a lit, paper book match over the hole located on the top left
for burner on the left, or the right hole for the right burner (Fig. 39 and Fig. 40). Push and turn the control knob
which is centered on the burner where the lit match is located, to "SEAR". If the burner does not light in 4 sec-
onds, turn the knob off, wait 5 minutes and try again.
NOTE:
Improper lighting procedures can cause
the LP tank flow control to activate, result-
ing in reduced heat output. If this is suspected,
reset flow control, shut off all burner controls and LP
cylinder valve, wait 30 seconds, then turn LP cylinder
valve on extremely slowly, wait five (5) seconds and
push and hold the ignition button and turn burner
valve on to "SEAR".
WARNING
Failure to follow the steps in the order shown may cause the Flow
Limiting Device to activate resulting in extremely low gas flow and
improper operation.
1
OFF
HI
2
3
All knobs must be in the OFF position before
opening LP tank valve.
Attach regulator hose assembly to tank.
Now open the LP tank valve two (2) full
turns min.
to
FIG. 39
24
FIG. 40