Advertisement
ACCUMULATOR INSTALLATION
Install the accumulator bracket on the right mainframe mast or lift valve mount, if applicable,
with the capscrews, lockwashers and spacers, if applicable, as shown in the Parts Section.
Install the accumulator in the bracket and secure with the hardware shown. Install fittings and
hoses to the cylinder and control valve as shown in the Parts Section. Use teflon tape on all
pipe fittings (except O-rings).
Install a solenoid valve on the mounting bracket with the supplied hardware as shown in the
Parts Section in this manual. While installing the fittings to the brake valve, the electrical coil on
the spool may have to be removed to make room. When reinstalling the coil, it is important to
use no more than 5 ft. lbs. (or 60in. lbs.) torque. WARNING: OVER TORQUE TO THE COIL
WILL RESULT IN HYDRAULIC FAILURE OF SPOOL.
TEMPERATURE GAUGE MOUNTING
Mount the temperature gauge where it is clearly visible to the operator. Attach the green (-)
wire from the negative post on the gauge to a grounded bolt on the tractor frame. Remove paint
if needed to make a good ground. Remove the pipe plug from the side of the hydraulic reservoir
and install the temperature sensor using thread sealing tape. Run the white wire from the (s)
sensor post of the gauge to the temperature sensor on the hydraulic reservoir tank.
For all tractors using a boom mower, a wheel weight will be required for the rear left side
wheel. It will be necessary to mount the weight in the wheel using the long capscrews,
lockwashers, flatwashers, spacers (if applicable), and hex nuts per the diagram in the Parts
Section.
Installation is most easily done with a fork lift, inserting a fork in the center slot of the wheel
weight. The head of the capscrews is to be toward the OUTSIDE of the weight, with flatwashers
on both the inside and outside of the assembly.
The left rear tire may also be filled with a mixture of water and calcium chloride at about five
pounds per gallon. Tire air pressure should be maintained according to the Maintenance
Section.
(ASM-C-0055)
With the tractor on jack-stands, remove the existing hardware on the rear axle where
the axle braces will be mounted. Use a hoist to raise the axle braces to the correctly
matching mounting holes on the rear axle and the mainframe. Use the hardware shown in
the Parts Section to attach the braces to the tractor, DO NOT tighten until the mainframe
has been positioned onto the axle braces. The mainframe hardware will not be tightened at
this time.
When the mainframe is in position, remove the capscrews one at a time and apply a thread
locking agent. Reinsert the capscrews and tighten / torque to values noted in the torque chart
located in the Maintenance Section of this manual.
ASSEMBLY
(ASM-C-0012)
SOLENOID BRAKE VALVE
WHEEL WEIGHT MOUNTING
AXLE BRACE INSTALLATION
Assembly Section 2-22
(ASM-C-0025)
(ASM-MF-0013)
(OPTIONAL)
(ASM-C-0051)
Advertisement
