Advertisement
ASSEMBLY
REAR STOW BENGAL HOSE ROUTING
WARNING NOTE:
The sudden release of hydraulic pressure could cause the sudden
movement of very heavy parts. Anyone in the way of these parts could be severely hurt or killed.
DO NOT ALLOW these hydraulic hoses to BREAK or BURST. To prevent hydraulic failure make
sure the hoses do not pinch or stretch as boom moves. Measure TWICE, check TWICE then
proceed with caution.
Route the hoses through the space between the swivel and the mainframe. Connect the hoses
to the brake valve. Assemble the swivel clamp and place the return hose for the motor in the
middle and the pressure line on the bottom. Place the 1/4" hoses in the top clamp and wrap the
hoses with a split hose before tightening the clamp. If not all of the 1/4" hoses fit, route two of the
hoses above the clamp and secure them to the other hoses with a zip tie. Make sure there is
enough slack for all hoses to pivot at the joint where the main boom arm bends in the swivel, and
tighten the hoses in the clamp. Wrap the hoses on either side of the clamp with the hose wrap.
This will protect the hoses from abrasion and heat.
(ASM-T4 HOSE ROUTING-0001)
Assembly Section 2-19
Advertisement
