Advertisement
HOSE AND WIRE ROUTING
Attach two clamps to the right rear wheel well for proper hose/wire routing. Drill one
hole for each clamp. Use the lower rear corner of the wheel well as an origin for
measuring. The holes should be 10mm or 3/8" reamed to accept 3/8" hardware.
Measure along the back edge of the wheel well 10-1/2" from the origin. Use a
square to measure 2-½" up, from the last mark. Refer to the image below to see the first
hole.
The second hole should run parallel to the bottom edge of the wheel well. Mark the
hole 22" from the origin and 3-½" from the bottom edge. Use the images below for
reference.
NOTE: DO NOT CUT INTO TUBES / HOSES / WIRES WHEN DRILLING
THROUGH METAL OR PLASTIC!.
Place as many hoses in the clamp as will fit without compromising pressure. Then secure
the (2) HOSE CLAMP (06520013) to the holes drilled with (1 EACH) CAPSCREW,3/8 X 1 NC
(21630) and (1 EACH) NYLOCK NUT,3/8 NC (21627). The hoses that don't fit into the clamp
are to be secured to the others with zip ties. For protection of hoses in contact with metal
edges, wrap hoses with split hose sections and fasten with hose clamps or zip ties as needed.
ASSEMBLY
(ASM-JD-0068)
Assembly Section 2-10
Advertisement
