Advertisement
WHEEL WELL HYDRAULIC TANK INSTALLATION
Install all fittings and tubes into tank and tank filter as shown in the Parts Section illustration.
Insert tank sight glass onto the tractor side of the tank.
Place the tank in the mounting bracket on the axle brace as shown in the Parts Section.
Secure the tank with the hardware provided.
Install the filter gauge into the filter housing so that it points to the rear of the tractor and is
clearly visible to the operator. The tank breather cap is ready for use as the tank is filled. Some
of these items may already be installed.
When mounting a boom mower, a spacer kit is needed for both rear wheels (part #
06200637). After removing the wheels attach the spacer to the wheel portion of the axle with the
hardware provided. When you are ready to re-attach the wheel, the wheel goes on first then the
reinforcement ring and finally the hardware provided.
INSTALLING O-RING FITTINGS
Installing straight, 45º and 90º O-rings requires that the O-ring and washer be up against the
swivel body. Insert the swivel and turn in until the swivel is pointed in the desired direction and O-
ring contact is made. Hold swivel in set direction with a wrench and turn the O-ring nut away
from the swivel body and carefully tighten.
INSTALLING NATIONAL PIPE FITTINGS
Whenever installing a pipe fitting, wrap the threads clockwise (looking at the end) with teflon
tape. In this way, the tape will be tightened when installed. NOTE: It is not necessary to tape O-
ring fittings, or those installed in swivels.
PREFORMED TUBE INSTALLATION
Lay booms on floor so that the side with the clamp plates is up. Locate all tube clamps and
install them loosely onto the clamp plates.
Arrange the tubes and hoses as outlined in the Common Parts Section. Install the tubes
closest to the boom arm first, being careful not to pinch the tubes. Place the other tubes outside
of the first tubes. Snug all clamp bolts, but do not tighten. Check all tubes for correct alignment
and that none are pinched or bent. The clamp bolts can now be tightened.
GENERAL HOSE INSTALLATION
Refer to the Parts Section for detailed information about hoses and fittings for this
application.
(ASM-C-0011)
Secure hoses together with zip ties wherever loose. Wrap the hoses between the swivel and
main boom with the hose cover provided.
secondary boom with the hose cover provided. Where hoses may contact the frame or other
edges, wrap with split hose and secure with hose clamps or zip ties.
On non-cab units, the pressure and return hoses from the control valve will also need to be
routed inside the protective hose wrap. Cover the valve and valve fittings with the hose cover
and secure with the string provided.
ASSEMBLY
(ASM-C-0103)
WHEEL SPACERS
(ASM-C-0056)
(ASM-C-0088)
HOSE COVERING
Wrap the hoses between the main boom and
(ASM-C-0058)
Assembly Section 2-21
(ASM-JD-0099)
(ASM-C-0085)
Advertisement
