Locking The Door; Using The Shelves - Caple WF1105 Instruction Manual

When you use the wine cabinet for the first time or restart the wine cabinet after it has been switched
off for a long time, there could be a few degrees variance between the temperature you select and
the one indicated on the LED readout. This is normal and it is due to the length of the activation time.
Once the wine cabinet has been running for a few hours, the temperature display will re-gain
accuracy.
Internal Light
In order to reduce energy consumption, the LED light within this wine cabinet will automatically
switch off after 10 minutes. If you would prefer the LED light to remain on continuously, this is
possible. Please press and hold the "LIGHT" button for 5 seconds, the display will show "LP". After
4 seconds the display will revert back to normal and the light will remain on until manually switched
off.
If you would like to revert back and conserve energy (recommended), press and hold the "LIGHT"
button for 5 seconds, the display will show "LF". After 4 seconds the display will revert back to
normal, and the light will automatically switch off after 10 minutes.

Locking the door

The door lock keys are located inside the plastic bag that contains the instruction manual. Insert the
key into the lock and turn it anticlockwise to unlock the door. To lock the door do the reverse
operation making sure metal pin is engaged completely. Remove the key and place it in a secure place
for safekeeping.

Using the shelves

To prevent damaging the door gasket, make sure the door is fully open when pulling shelves out
•
of the rail compartment.
For easy access to the storage content, you must pull the shelves approximately 1/3 out of the rail
•
compartment; however this unit was designed with a notch on each side of the shelf tracks to
prevent bottles from falling.
Put the shelf gap (left and right) under the square plastic block, lift the shelf, then pull the shelf
•
from the wine cabinet.
6