Related Manuals for Caple WF1548
Summary of Contents for Caple WF1548
- Page 1 Instruction manual for freestanding wine cabinet Model code: WF1548 Contact Caple on 0117 938 7420 or for spares www.caple.co.uk ...
-
Page 2: Table Of Contents
Recommended storage temperature Recommended drinking temperature Thank you for buying your new Caple wine cabinet. To ensure that you get the best results from your new purchase, we strongly suggest that you read this instruction manual thoroughly before use. This manual contains installation advice, usage instructions and other important facts about your wine... -
Page 3: Important Warnings And Advice
• Ensure that you fully understand these instructions before operating this appliance. • Caple are NOT responsible for: - 1. Damage caused by incorrect, mistaken or irrational use. 2. Any errors in this manual or for any damage linked to or following the provision, performance or use of any wine cabinet. -
Page 4: Installation Instructions
Installation instructions IMPORTANT: Once in the final location wait 12 hours before switching your wine cabinet on for the first time Before turning the wine cabinet on ensure it is perfectly level, this will minimise any vibrations. Your cabinet is equipped with 4 adjustable feet. However, we recommend that you tighten the back feet to the maximum and then use the front feet to level the cabinet. -
Page 5: Operating Your Wine Cabinet
Operating your wine cabinet and setting the temperature The wine cabinet should be placed where the ambient temperature is between 16-32 deg centigrade. If the ambient temperature is above or below this range, the performance of the unit may be affected. For example, placing your unit in extreme cold or hot conditions may cause interior temperatures to fluctuate and prevent it reaching the set temperature. -
Page 6: Setting The Temperature
Setting the temperature Each cooling compartment of the wine cooler is independently controlled. To set the temperature: Connect the power cord to a properly grounded outlet. In the event of a power interruption, all • previous temperature settings are automatically erased and each compartment will default to a preset temperature setting of: 7°C for upper compartment, 7°C for middle compartment and 12°C for lower compartment. -
Page 7: Locking The Door
Locking the door The door lock keys are located inside the plastic bag that contains the instruction manual. Insert the key into the lock and turn it anticlockwise to unlock the door. To lock the door do the reverse operation making sure metal pin is engaged completely. Remove the key and place it in a secure place for safekeeping. -
Page 8: How To Change The Door Opening
How to change the door opening This appliance has reversible doors but is delivered with a right hinged door. The left hand hinge kit comes with the unit (in the box), should you wish to reverse the hinge on your unit. Fig.A Fig.B Fig.C... -
Page 9: Care And Maintenance
Care and maintenance Cleaning your wine cabinet Turn off the power, unplug the appliance, and remove all items including shelves and rack. • Wash the inside surfaces with a warm water and baking soda solution. The solution should be • about 2 tablespoons of baking soda to 2 pints of water. -
Page 10: Troubleshooting Guide
Problems with your wine cabinet You can solve many common wine cabinet problems easily, saving you the cost of a possible service call. Try the suggestions below to see if you can solve the problem before calling Caple Service. Troubleshooting Guide... -
Page 11: Defrosting/Condensation
Defrosting/condensation Your wine cabinet is designed with an “Auto-cycle” defrost system. When the RUN cycle is OFF, the refrigerated surface of the wine cabinet (interior rear wall) defrosts automatically. The defrost water is channelled into a drain pan which is located at the back of the wine cabinet next to the compressor from where it evaporates. - Page 12 Caple Fourth Way Avonmouth Bristol BS11 8DW www.caple.co.uk...