Operating you wine cabinet and setting the temperature Using the shelves How to change the door opening Fitting a kitchen plinth Installation dimensions Care and maintenance Troubleshooting guide Caple Service contact details Defrosting/condensation The humidity system Recommended storage temperatures Recommended drinking temperatures...
The wine cabinet should be installed in a suitable place in order to avoid touching the compressor with the hand. If the supply cord is damaged, it must be replaced by a Caple service agent or a similarly qualified person in order to avoid a hazard.
Plug the wine cabinet into an exclusive, properly installed-grounded wall outlet. Do not under any circumstances cut or remove the third (ground) pin from the plug. Any questions concerning power and/or grounding should be directed toward a certified electrician or an authorised Caple service centre. Attention •...
Operating your wine cabinet and setting the temperature Please use the cabinet within a ambient temperature range of 5-32 ºC, if the ambient temperature is higher or lower than this, it will cause the temperature to fluctuate in the cabinet, which may prevent it from reaching 3-18 ºC. Control panel •...
Using the shelves • To prevent damaging the door gasket, make sure to have the door all the way opened when pulling shelves out of the rail compartment. • For easy access to the storage content, you must pull the shelves approximately 1/3 out of the rail compartment, however this unit was designed with a notch on each sides of the shelf tracks to prevent bottles from falling.
How to change the door opening This appliance has reversible doors but is delivered with a right hinged door. The left hand hinge kit comes with the unit (in the box), should you wish to reverse the hinge on your unit. 1.
This model is recessed to fit a kitchen plinth. A H55mm vent slot is required in the plinth to ensure air is able to ventilate correctly, see the diagram below Failure to include this vent slot will invalidate the guarantee Alternatively the Caple GRILL/SENSE600 stainless steel plinth grill can be installed. Installation dimensions...
Care and maintenance Cleaning your wine cabinet • Turn off the power, unplug the appliance, and remove all items including shelves and rack. • Wash the inside surfaces with a warm water and baking soda solution. The solution should be about 2 tablespoons of baking soda to 2 pints of water.
Problems with your wine cabinet You can solve many common wine cabinet problems easily, saving you the cost of a possible service call. Try the suggestions below to see if you can solve the problem before calling Caple Service. Troubleshooting Guide...
Defrosting/condensation Your wine cabinet is designed with an “Auto-cycle” defrost system. When the RUN cycle is OFF, the refrigerated surface of the wine cabinet (interior rear wall) defrosts automatically. The defrosted water is channelled into a drain pan which is located at the back of the cabinet next to the compressor from where it evaporates.
Page 13
Caple Fourth Way Avonmouth Bristol BS11 8DW www.caple.co.uk...
Need help?
Do you have a question about the Wi6117 and is the answer not in the manual?
Questions and answers