Table of Contents
Advertisement
Replacing the cutter inserts:
1.
the screws that secure the retaining clamps. Note: A common mistake is to use an
Allen wrench to remove the TORX screws. This will strip the screws, making the
inserts nearly impossible to remove.
2.
3.
(acetone or alcohol) and blow them dry with the air gun supplied in the accessory kit.
4.
of the cutter body. This will ensure the alignment of the inserts.
5.
are evenly seated and tightened securely.
SAFETY NOTE: FAILURE TO SECURELY TIGHTEN THE INSERT CLAMPS
NATIONAL
INCORPORATED
BOSCH MOTOR ADDENDUM
Using the "TORX" wrench provided in the accessory kit, loosen
Slip the insert out of the body.
Thoroughly clean the cutter body and the clamps in a solvent
Replace the inserts by pushing them as far as possible to the back
Alternate the tightening of each screw 2-3 times, until the clamps
PRESENTS A SAFTEY HAZARD.
Figure A1- Bosch Cutter Body
Tel: 434-295-9126 Tech Support: 800-247-9796 Fax: 888-239-0778
100 Avon Street, P.O. Box 1547
Charlottesville, VA 22902
Revision Date: 11/98 Page - 53 -
Advertisement
Table of Contents
