Table of Contents
Advertisement
Bent Tube Removal
Installing the 455 Balanced Regulator onto a
SL 17C, SL 27
Part #
100-100
100-204
505-455
520-042
VIDEO
1.1 SuperFlow
350 Regulator
®
Removal
Tools Required:
• Socket Wrench
• 1 3/8" inch socket and/or P/N 525-
625 Regulator Mount Socket Wrench
(Found in 525-620 Tool Kit)
• 3/8" Drive Extension—Minimum 3" in Length
•
#1 Phillips Head Screwdriver
• Open-End Wrench 7/16" and (2) 7/8" and 11/16"
• Slip Joint Pliers and a Cloth
1.1.1 Bent Tube Removal
1. Always start removal at the side block end.
Loosen the tube with the 11/16 inch wrench. The
free swiveling mount nut on this end of the bent
tube can be un-threaded completely and can
slide down the tube.
12
, KM 37 or KM 57 Helmet
®
Parts Included in the 525-765 Kit:
Description
Warranty Card
Installation Guide, 455 Regulator Kit
455 Balanced Regulator
Tie Wrap
How To: Conversion Kit,
455 Regulator for KM 37,
KM 57, SL 17C or SL 27
®
Helmet
https://www.youtube.com/
watch?v=qCucRRcp1fo
© MMXXI Kirby Morgan Dive Systems, Inc. All rights reserved. Document # 210607001
SuperFlow® 350 Regulator Removal
Qty
1
1
1
2
Always start removal at the side block end.
2. Loosen the lower bent tube nut by using the
two 7/8 inch wrenches. Place one wrench on the
bent tube mount nut and the second on the
regulator inlet jam nut. Turn only the outer nut
on the bent tube to loosen the bent tube.
3. With the two mount nuts free; the bent tube
assembly can be pulled straight out and away
from the regulator. The bent tube assembly
can be rotated back and forth to aid removal, if
necessary.
Advertisement
Table of Contents
