Kirby Morgan 525-100 Quick Start Manual

For SL 17B, 17C, 27, KM 37/57 Helmets
Part Number
510-597
510-598
510-599
520-039
520-046
520-072
The Hot Water Shroud should be used whenever diving in water colder than 34 °F (1 °C). The shroud completely
encases the side block, bent tube and demand regulator to provide efficient gas heating. It is designed to be
integrated with a hot water supply to help maintain breathing gas temperature at a level acceptable for use by
the diver. Even with water temperatures at 34 °F (4 °C) or slightly above, the diver can experience discomfort
and severe heat loss through the respiration process. Heating the diver's gas is especially important in cold
water and/or when breathing mixtures of helium and oxygen. For these reasons, Kirby Morgan recommends
the use of the hot water shroud in waters colder than 34 °F (1 °C).
The P/N 525-100 Hot Water Shroud Kit shown in this manual fits most KM model helmets and BandMasks
but DOES NOT FIT the Stainless Steel models (KM 77, 37SS, KM 97, KM Diamond) or the KM 47. For informa-
tion regarding hot water shroud kits for these models, please contact your Kirby Morgan dealer or e-mail
sales@kirbymorgan.com.
Tools Required:
• 1/4 inch Flat Blade Screwdriver
• Open-end Wrench
7/8 inch
• Torque Wrench with Open End Attachments
7/8 and 11/ 1 6 inch
© MMXXII Kirby Morgan Dive Systems, Inc. All Rights Reserved
Kirby Morgan Dive Systems, Inc.
www.KirbyMorgan.com email: kmdsi@KirbyMorgan.com
Part #525-100
Hot Water Shroud Kit
& KMB 18/28 BandMasks
Description
Side Block Shroud
Corrugated Tube
Regulator Shroud
Tie Wrap
1" Flange
Sticker, KMDSI Oval Small
1430 Jason Way Santa Maria, California 93455
Phone: 805/928-7772
Document # 221222001
Fax: 805/928-0342
®
Qty
1
1
1
2
2
2
Page 1 of 4
®
,
®