Lifting And Supporting The Vehicle - BRP Can-Am COMMANDER 2021 Series Operator's Manual

L L I I F F T T I I N N G G A A N N D D S S U U P P P P O O R R T T I I N N G G T T H H E E V V E E H H I I C C L L E E
F F r r o o n n t t o o f f V V e e h h i i c c l l e e
1. Place vehicle on a flat non slippery
ground.
2. Ensure vehicle shift lever is set to
PARK.
3. Install an hydraulic jack under the
front skid plate.
4. Lift front of vehicle and install a
jack stand on each side under
frame section.
1. Front of vehicle
2. Frame section
5. Lower hydraulic lift and ensure ve-
hicle is supported safely onto both
jack stands.
R R e e a a r r o o f f V V e e h h i i c c l l e e
1. Place vehicle on a flat non slippery
ground.
2. Activate 4WD mode.
3. Ensure vehicle shift lever is set to
PARK.
4. Install an hydraulic jack under the
skid plate.
5. Lift rear of vehicle and install a jack
stand on each side under frame
section in front of rear wheel.
1. Lifting location under skid plate
2. Frame section to install jack stands
6. Lower hydraulic lift and ensure ve-
hicle is supported safely onto both
jack stands.
113