BRP Can-Am COMMANDER 2021 Series Operator's Manual page 145

3. Seat tire outer bead in the
shoulder of the beadlock inner
ring and center the tire.
2. Install all beadlock screws by hand
to avoid cross threading.
N N O O T T I I C C E E
D D o o n n o o t t u u s s e e a a n n i i m m p p a a c c t t w w r r e e n n c c h h f f o o r r
i i n n s s t t a a l l l l i i n n g g b b e e a a d d l l o o c c k k s s c c r r e e w w s s . . T T h h e e
r r i i s s k k o o f f s s c c r r e e w w b b r r e e a a k k i i n n g g o o r r s s c c r r e e w w
s s t t r r i i p p p p i i n n g g i i s s h h i i g g h h w w h h e e n n u u s s i i n n g g a a n n
i i m m p p a a c c t t w w r r e e n n c c h h . .
3. Apply the F F I I R R S S T T tightening torque
using the following sequence.
N N O O T T I I C C E E
T T o o e e n n s s u u r r e e e e v v e e n n p p r r e e s s s s u u r r e e o o n n t t h h e e
b b e e a a d d l l o o c c k k c c l l a a m m p p r r i i n n g g , , t t i i g g h h t t e e n n
s s c c r r e e w w s s a a f f e e w w t t u u r r n n s s a a t t a a t t i i m m e e . .
T T i i g g h h t t e e n n i i n n g g T T o o r r q q u u e e
Beadlock
screws
(FIRST
TORQUE)
14 ± 1 Nm (124
± 9 lbf-in)
MAINTENANCE PROCEDURES
9
1
5
16
12
4
F F I I R R S S T T S S E E Q Q U U E E N N C C E E
4. At this time check if the tire is still
centered on wheel. Reposition it if
necessary.
5. Apply the S S E E C C O O N N D D tightening tor-
que using the same sequence.
N N O O T T E E : :
The beadlock clamp ring should be in
contact with the beadlock inner ring.
The beadlock clamp ring can flex
slightly to match the tire bead. IT IS
NORMAL.
T T i i g g h h t t e e n n i i n n g g T T o o r r q q u u e e
Beadlock
screws
(SECOND
TORQUE)
9
1
5
16
12
4
S S E E C C O O N N D D S S E E Q Q U U E E N N C C E E
6. Verify the gap between tire and
beadlock clamp ring, it should be
practically equal all around the
ring.
13
7
3
11
15
6
2
10
14
8
29 ± 1 Nm (21 ±
1 lbf-ft)
13
7
3
11
15
6
2
10
14
8
143