Security Code; Access Code - Viking K-1200-IP Series Product Manual

Vandal resistant voip entry phone system with built-in directory and 12 button auto dialer

Table of Contents

9. Entry Code Database

Clicking on the "Entry Code Database" button will open the Entry Code Database screen.

The Entry Code Database will then download, this can take over a minute. The Entry Code Database will allow you to

program the Relay Function, Relay 1 or 2, once only (one time use only), Entry Type (Card, Keyless or both), Keyless

Code, Proximity Card #, Facility Code, Day of week, Time of Day and Tenant Name. Tenant names are stored locally

on the PC and are not uploaded. When "Card + Keyless" is selected, a valid card must be presented and the keyless

code entered within 15 seconds.

Keyless Entry Code and Proximity Card logging can be set to Log Errors. With Log Errors selected, (factory setting) the

K-1200-IP will not only log all valid Keyless Entry Code and Proximity Card entries, but also log any errors, incorrect

codes, or non-valid card reads.

Keyless Entry Code and Proximity Card logging can also be set to Live Logging. With Live logging selected and the

K-1200-IP programming software open and connected to a unit, each Keyless Entry Code entered or Proximity Card

read will immediately open the Event Log screen and display the latest entry.

11. Security Code

The security code allows the user/installer to program the K-1200-IP Series Phone. It is recommended that the factory

set security code be changed. Factory Setting: 845464

Note: The security code must be 6 digits and cannot include a Q or a #.

The Access Code is used for remotely operating the relays (Doorstrike, Mag-Lock, etc) by calling into the unit. This

code provides basic security and only allows operation of the relays and not the ability to change any of the programming

parameters. Once entered, any of the "Remote Access Operation Commands" can be used. The code can be 1 - 6

digits in length and cannot contain a "Q" or "#". Simply call the K-1200-IP phone, the unit will automatically answer the

line and output one beep. You then enter the programmed 1 - 6 digit access code, 2 beeps should be heard. You can

now enter any "Remote Access Operation Commands" (see page 22). This code will also enable audio to/from the

speaker and the caller. The access code can be cleared (by leaving the field blank) if this additional level of security is

not required. Factory Setting: 123456

Table of Contents

K-1200-ipK-1200-ip-ewp