Blizzard 810SS Assembly & Operation Manual page 9

Mounting & Dismounting Instructions
Prior to operating your Power Plow, review the Mounting & Dismounting
Instructions label at the driver's side rear of the moldboard (shown below).
MOUNTING
1.) Position the skid steer close to the plow attachment and align the mounting
points on the skid steer plate and plow attachment plate.
2.) Tilt the skid steer plate forward and position the top edge of the plate under
the receiving pocket on the top edge of the plow attachment plate. CAUTION:
Keep fingers away from skid steer mounting points. Slightly raise the
arms on the skid steer and tilt the skid steer plate toward the cab. The attach-
ment should now be flush with the skid steer mount.
3.) Engage both locking levers on the skid steer by rotating each handle 90˚ into
a horizontal position. The attachment is now properly fastened to the skid steer.
4.) Proceed to attach both 3/4" diameter hydraulic hoses from the manifold to
the auxiliary hydraulic connectors located on the skid steer. Note: Depending
on the skid steer model, it may be necessary to initiate an auxiliary hydraulic
switch on the skid steer prior to operating the plow.
5.) Complete the mounting procedure by attaching the electrical connection on
the wire harness to the auxiliary electrical connection on the skid steer.
Plow Attachment
SKID STEER MOUNTING &
DISMOUNTING INSTRUCTIONS
DISMOUNTING
1.) Lower the plow on a flat, level surface and turn the engine off.
2.) Disconnect the electrical connection at the auxiliary power location.
3.) Disconnect both 3/4" diameter hydraulic hoses from the auxiliary hydraulic
connectors.
4.) Disconnect the plow attachment by rotating both of the locking levers 90˚
until they are in the vertical position.
5.) Start engine and slowly tilt the skid steer plate forward until the top edge of
the plate clears the plow attachment plate.
6.) Back skid steer away slowly – The disconnect procedure is now complete.
WARNING: Read and understand all warning labels prior
to operating your skid steer blade. Failure to follow this
instruction may result in serious injury or death.
B
C
A
B
Lever
Receiving
Holes
A Skid steer plate attaches under the
top lip of the plow attachment.
B With the plow attachment flush to
the skid steer plate, engage both
locking levers on the skid steer by
rotating each handle 90˚ into a
horizontal position. The levers will
slide through the receiving holes
in the plow attachment plate. The
plate is now securely mounted to
the skid steer.
C Connect both hydraulic hoses & the
electrical harness to the skid steer.
Should the Mounting & Dismounting Instructions
label or any of the labels that came with your
snowplow become hard to read or wear off, contact
your local dealer or call our Customer Service
Department at 1-888-680-8600 for replacements.
Mounting & Dismounting Instructions 07
1095-2-00