Wiring Diagram - Makita TM30D Technical Information

7

Wiring diagram

Wiring to DC motor
Connect Flag receptacle to DC motor as shown below.
Flag
receptacle
Lead wire
Wiring to Motor housing set
Do not put any Lead wires on Dial.
Controller
Dial
Terminal
Put Closed end splice and Fuse in this
space.
If LED circuit is repaired:
Put Non-insulated terminal protected
by Polyolefin tube in this space.
Red mark
Put DC motor with the flag
receptacle facing Switch lever side.
Switch DC motor
Boss
Closed end
Rib F
splice
Fuse
Put the lead wires of LED circuit in the
following space:
- between the rib B and the rib C
- between the rib C and the rib D
- between DC motor and the inner wall
- between the rib E and the rib F
Fig. 7-1
DC motor
Fig. 7-2
Put LED circuit in Motor housing L as shown below.
LED circuit
Put the lead wires of LED circuit in
this groove.
Switch lever
Rib E
Rib D
13 / 13
Lead wires of
LED circuit
Motor
housing L
Section A-A
A
Rib C Pin B
Rib B
Put the lead wires of LED circuit in the
following space:
- between the pin A and the pin B
- between the pin B and the rib A
LED
circuit
A
Pin A
Rib A