Wiring Diagram - Makita DHR263 Technical Information

W
iring diagram
Fig. D-2
1. Connect Brush holder's lead wire (red) to M1 terminal of
Switch and the black one to M2 terminal while keeping
their connectors in 90 degrees as shown below.
M1 terminal
Handle
set (L) side
Fig. D-3
Brush holder's Lead wires have to be tightened between
Switch and Lead wire holder by Compression spring 10.
Route Switch's lead wires and
Controller's lead wires between
Ribs A and B.
Note: Put Black lead wire of Switch
on the other lead wires.
Route Switch's lead wires and
Controller's lead wires between
Ribs B and D, Ribs B and C.
Put Line filter in here.
Put Lead wires of Controller
between Ribs E and F.
Fig. D-4
First, pass Brush holder's lead wires through Line filter (2 holes type), then
pass the wires through Line filter (single hole type), if Line filters are used.
Line filter Line filter
(single hole type) (2 holes type)
Wiring to Switch
90 degrees
Wiring in Housing set (L)
Switch
Rib A
Rib B
Line filter
Rib E
Put Line filters to the place here,
if they are used.
Wiring of Brush holder
Housing set (L) side
Fix Brush holder's lead wires
with these lead wire holders.
Housing set (R) side
2. Bent Connector of Brush holder's lead
wire (black) toward the red one side.
Fix Brush holder's lead wires with these Lead
wire holders and the groove.
Lead wire
holders
Put Closed end
splices in here.
Rib C
Rib C
Compression spring 10
Rib D
Rib F
To Controller
P 21/ 22
M2 terminal
Handle
set (R) side
Groove
Lead wire holder
Fix Brush holder's lead wires
with this Lead wire holder.
Brush holder