Circuit Diagram - Makita TM30D Technical Information

6

Circuit diagram

Terminal
＋ T －
AWG16
AWG16
AWG22
AWG16
Fuse
Circuit of Switch
COM
6-1 Repair of LED circuit
Repair LED circuit with Non-insulated terminal and Polyolefin tube (inner diameter 4mm) as drawn.
Put Non-insulated terminal protected by Polyolefin tube in the position in Fig. 7-2 after repairing.
Cut the lead wires of LED circuit to the appropriate length so that they are fit into Motor housing set in the position in Fig. 7-2.
Remove and repair Polyolefin tube of the lead wires of LED circuit if necessary. However, do not remove Polyolefin tube in the
range between the rib F and LED circuit in Fig. 7-2.
Crimp with
Non-insulated terminal.
Controller
Red/AWG24
Black/AWG24
Flag receptacle
with lock (#250, t=0.8)
Closed end splice
AWG16
Flag receptacle
with lock (#187, t=0.8)
Dial
AWG24
Controller
NO
Shrink Polyolefin tube.
Fig. 5-1
Switch
COM NO
AWG16
AWG22
AWG24
Fig. 6-1
End of
Polyolefin tube
End of
Non-insulated
terminal
End of
Polyolefin tube
Red/AWG24
Black/AWG24
Polyolefin tube
12 / 13
Insulated straight receptacle
Without lock (#187, t=0.8)
Flag receptacle
Without lock (#187, t=0.8)
DC motor
AWG16
AWG16
LED circuit
Color index of lead wires'
sheath
Orange
White
Blue
Yellow
Red
Black
2mmor more
2mmor more
LED circuit
Red mark