Wiring Diagram - Makita HM1801 Technical Information

W
iring diagram
We are explaining the wiring in three sections. (Fig. 37)
Fig. 37
[1] Crank housing cap
[1] Wiring in Crank Housing Cap
Note: Illustrated below in Fig. 38 is Crank housing cap viewed from Cap cover side.
Fig. 38
Fix the following lead wires with
Lead wire holders A, B and C;
A Two orange lead wires
(Field lead wire, Lead wire from Brush holder)
B Two purple lead wires
(Field lead wire, Lead wire from Brush holder)
Two Field lead wires (black)
C Two Field lead wires (black)
When fixing Lead wires with
Lead wire holders A and B,
be sure that all the wires are tight
between the Lead wire holders and
the opening of Motor housing B.
Cap cover side
Lead wire holder A
Orange lead wires
(Field lead wire, Lead wire
from Brush holder)
Insulated connector
Line filter
(See the illustration below.)
Lead wire holder C
Field lead wire (black)
Line filter
Wind Field lead wires (black) around
Line filter as illustrated to right,
then cover the Line filter with Sponge.
Motor housing B
[3] Cap cover
Motor housing B
Top cover
Rear case [2] Handle sub base
Route the following six lead wires
through this opening of Motor housing B:
*Four Field lead wires
(orange, black, black, purple)
*Two lead wires from Brush holder
(orange, purple)
If Noise suppressor is used,
be careful not to move Noise
suppressor out of place when
connecting its lead wires with
the insulated connector in
Cap cover.
Lead wire holder B
Noise suppressor
If noise suppressor is used, put here
in place after wrapping with Sponge.
Purple lead wires
(Field lead wire, Lead wire
from Brush holder)
Insulated connector
Pilot lamp
Fix Pilot lamp with this holder.
Sponge sheet
If Line filter is used,
put Sponge sheet under it.
Field lead wire (black)
Line filter
Sponge
P 15/ 18
Lead wires