Page 1
Digital HDTV Over-the-Air Antenna w/built-in KING SureLock Digital TV Signal Meter ™ Owner’s Manual OA8200 WHITE • OA8201 BLACK 11200 Hampshire Avenue South, Bloomington, MN 55438 PH 952.922.6889 || FAX 952.922.8424 || kingcontrols.com...
Thank you for choosing a KING Antenna! NOTE: Before beginning the installation on page 2, see page 5 for information about the MB8000 Mounting Plate. You must install the included wall mount Power Injector to operate the KING Jack antenna (page 5). SPECIFICATIONS Dimensions: 11.25”...
Page 3
For roof thicknesses 1 1/2” to 5” use the assembly as shipped. For roof thicknesses 5” to 6 1/2” use the longer connector. IMPORTANT! You must install the included wall mount switch KC# PB1000 to operate the KING Jack antenna. (See page 5) Page 2...
Page 4
EXTERIOR BASE MOUNT INSTALLATION (FIG. 2) IMPORTANT! The installer is responsible for determining the most appropriate fasteners to secure the base mount to the roof and weatherproofing all holes with sealant. The installer is responsible for sealing all existing holes when replacing an existing antenna mount.
Page 5
Knob fits into the raised ring on the enclosure.) Fasten knob to connector with screw. 4. Route the coax around the raised ring as shown and connect the coax to the RF connector on the KING SureLock signal meter.
Page 6
WALL MOUNT POWER INJECTOR INSTALLATION (FIG. 4) 1. Make all connections as shown. The Wall Mount Power Injector: • Can be mounted in most standard electrical boxes. • Requires a +12 Volt DC power source. (Inadequate voltage may cause the green LED to not illuminate and the unit to not function properly.
KING for repairs. A certified dealer must not perform any repair without first contacting KING for a Service Order Number. KING will advise the dealer on how to proceed with any repairs.