Connecting To The Gas Supply - Baumatic BMEH94E1G Instructions For Use And Installation

Connecting

CONNECTING TO THE GAS SUPPLY

WARNING: these tasks may only be carried out by a qualified technician, authorized by the gas distributing company or

authorized service center!
The appliance must be connected in compliance with all relevant regulations, and it may only be used in well ventilated /

aerated rooms.
The category with the related types of gas can be used are included in Table ʺADAPTATION TO A DIFFERENT

.
TYPE OF GASʺ
This appliance is not suitable for connection to a burning fumes exhaust system (i.e. a chimney).

CAUTION: The gas cooking appliance use may cause heat, humidity and products of combustion in the room where is

installed. Ensure that the kitchen is well ventilated especially when the appliance is in use: keep open any natural
ventilation holes or install a mechanical ventilation device (mechanical extractor hood). Prolonged intensive use of the
appliance may call for additional ventilation, for example opening of a window, or more effective ventilation, for example
increasing the level of mechanical ventilation where present. Special care must be taken to ensure adequate ventilation /
aeration (a = min. 100 cm
Connection
Incorrect connection may destroy parts of the appliance, making the warranty void.

Connection cable on the back of the appliance should be led in such way that it does not

touch the appliance back wall, as this part will get very hot during operation.
The following cables can be used for connection:
• H05GG-F
2
).
When connecting the appliance to the gas supply, follow the regulations of the local gas

distributor.
On the lower side, the cooking hob is fitted with a gas connection plug with a thread.

When connecting, the knee should be held firmly to prevent it from rotating.

For sealing of the connection joints, use a non-metal approved gaskets and approved

sealants.
The gaskets should only be used once. The thickness of the flat non-metal gaskets should

not be deformed more than by 25 percent.
To connect the appliance to the gas supply, use a tested and certified flexible hose.

The flexible connection hose should be able to move freely.

It should not come into contact with the movable parts of the furniture or the bottom of the

cooking hob.
If an electric oven is built into the kitchen element under the cooking hob, it should be fitted

with a cooling fan.
After connecting the gas hob, check the joints for any leaks.

7