Advertisement
Available languages
Available languages
Installing the foam
gasket
Installation procedure
(with springs)
Installation procedure
(with fixing brackets)
CONNECTING TO THE POWER MAINS
Before inserting the appliance into the opening in the kitchen worktop, the supplied foam
gasket must be attached to the lower side of the glass ceramic (glass) cooking hob.
Do not install the appliance without the foam gasket!
The gasket should be attached to the appliance in the following way:
▪ Remove the protective film from the gasket.
▪ Then, attach the gasket to the lower side of the glass, approximately 2-3 millimetres from
the edge.
▪ The gasket must be attached along the entire length of the glass edge and should not
overlap at the corners.
▪ When installing the gasket, make sure that the glass does not come into contact with any
sharp objects.
• Worktop must be placed absolutely horizontal.
• Suitably protect the edges of the cut aperture.
• Connect the cooking hob to the mains power supply (see instructions for the connection of
the cooking hob to mains power supply).
• Put the supplied springs in their places.
• Insert the hob into the cut aperture.
• Press the hob firmly towards the worktop from above.
The cooktop is fixed to the unit by means of the brackets and accessories provided. Holes
are provided in the bottom of the tray where you can attach the screws C that hold the
brackets B in place.
The appliance may only be connected by an authorized skilled technician.
Electric system protection should comply with all relevant regulations.
The connection clips can be accessed when the connection clip covers are opened /
removed.
Before connecting the appliance, make sure the voltage indicated on the rating plate is
consistent with the voltage in your home network. Connection voltage should be checked
by a qualified technician using a corresponding measuring device!
The rating plate with basic information is attached on the lower side of the hob.
The appliance is manufactured for use with the power supply voltage 220-240 V ~.
In order to make a fixed connection to the mains, insert an all-pole circuit breaker between
the appliance and the mains. This device shall have a contact separation in all poles,
providing full disconnection under overvoltage category III conditions.
Given the protection from the risk of fire, appliances of this type may be installed in a
worktop next to a piece of kitchen furniture that is taller than the appliance (when installed);
however, in this case, a kitchen furniture element must be installed on the other side,
adjacent to the appliance.
The current conducting and isolated parts must be protected from any possibility of direct
contact.
WARNING!
Before any intervention, disconnect the appliance from the power mains. Connect the
appliance in compliance with the electric connections diagram supplied; make sure the
relevant network voltage is observed! The ground wire should be connected to the clip
indicated by the earth symbol.
The mains cable should be fed through the fastening clip which protects it from being
accidentally pulled out.
After connecting the appliance, turn on all cooking zones / heaters for approximately three
minutes to make sure they are operating correctly.
6
Advertisement
