JLG 1500SJ Operation And Safety Manual page 57

ONLY USE THE PLATFORM LEVELING OVERRIDE FUNCTION FOR SLIGHT LEVELING OF
THE PLATFORM. INCORRECT USE COULD CAUSE THE LOAD/OCCUPANTS TO SHIFT OR
FALL. FAILURE TO DO SO COULD RESULT IN DEATH OR SERIOUS INJURY.
3. Platform Leveling Override
A three position switch allows the operator to
adjust the automatic self leveling system. This
switch is used to adjust platform level in situa-
tions such as ascending/descending a grade.
4. Axle Extend/Retract
Allows the operator to extend or retract the
axles. The axles can only be extended or
retracted while the machine is being driven
forward or reverse.
5. Horn
A push-type HORN switch supplies electrical
power to an audible warning device when pressed.
3121261
SECTION 3 - MACHINE CONTROLS AND INDICATORS
6. Indicator Panel
The LED Indicator Panel contains indicator lights that signal
problem conditions or functions operating during machine
operation.
Within about 2 seconds of pulling the Power/Emergency
Stop switch out, the machine will perform a diagnostic
check of the various electrical circuits, and if everything is
OK, the platform alarm will beep once. During this time the
lights on the indicator panel will also blink once as a bulb
check.
7. Boom Control Select
during lift, telescope, swing, and drive movements.
NOTE: • While operating lift up, the boom may also telescope out.
• While operating lift down, the boom may also telescope in.
• While operating swing or drive, the boom may lift up or lift
down.
• While operating telescope in, the boom may lift down when at
high boom angles and the creep light is flashing.
– JLG Lift –
Automatic Mode:
When the Boom Control is positioned to Auto-
matic, lift and telescope movements are coordi-
nated by the JLG control system and the
automatic platform leveling feature is active
3-13