Check Substrate Conveyor Tension; Check Spreading Conveyor Tension; Check Elevator Chain Tension - Javo Traytopper User Manual

5.5 Check substrate conveyor tension

Check the substrate conveyor belt tension before you start working with
the machine.
Procedure:
1. Check the substrate conveyor belt tension. The correct tension is
obtained when the belt in the middle deflects ± 40mm.
2. Adjust the belt tension if necessary .
a. Loosen the four screws (B) to the block bearings.
b. The tension can be adjusted by simultaneously turning both
sides of the ground belt (A).
c. Tighten the four screws (B) to the block bearings.

5.6 Check spreading conveyor tension

Check the spreading conveyor belt tension before you start
working with the machine.
Procedure:
1. Check the spreading conveyor belt tension. The correct tension is
obtained when the belt in the middle deflects ± 10mm.
2. Adjust the belt tension if necessary .
a. Loosen the four screws (B).
b. The tension can be adjusted by simultaneously turning
both sides of the belt (A).
c. Tighten the four screws (B).

5.7 Check elevator chain tension

Check the elevator chain tension before you start working with the
machine.
Procedure:
1. Check the elevator chain tension. The correct tension is obtained when
the chain in the middle deflects ± 40mm.
2. Adjust the chain tension if necessary .
a. The tension can be adjusted using the two clamping nuts,
located on opposite sides of the elevator housing.
b. Tighten the nuts (A) on both sides of the elevator equally.
The tension of the chain should not be too tight.
Version 2016-2
User Manual Javo Traytopper
C
B
B
A
12