Drawings And Schemes; Spare Parts - Javo Traytopper User Manual

Table of Contents

Advertisement

Problem
Not the entire width of the
spreading belt is covered with
material.
Spreading material is blocked.

7.6 Drawings and schemes

The drawings accompanying this machine are supplied in a separate file. The wiring diagrams are included in the
electrical cabinet of the machine.

7.7 Spare parts

Only original spare parts and accessories of Javo BV may be used on the machine.
Javo BV advises you to take certain parts in stock because of wear sensitivity and / or any expected downtime for re-
ordering of the parts.
The spare parts list can be found on the assembly drawings. These can be found on JavoNet.
When ordering (spare) parts at Javo BV, the following information must be included: drawing number, item number,
desired length (if applicable) and the desired number of pieces.
7.8 JavoNet
We recommend you to register your machine on JavoNet. This way you get online access to all
technical drawings and documents pertaining to your machine.
Visit our website (www.javo.eu) for more information and to request an account.
7.9 Customer support and advice
Our technical department will answer your other questions about repair and maintenance of your machine and
spare parts. We can help you with any questions regarding the purchase, use and settings of products and
accessories.
8 Disposal of machine or machine parts
Follow all instructions described in this manual, in particular chapter safety.
Perform the following steps when disposing the machine:
1. Decommission the machine and remove electric and pneumatic power.
2. Drain and remove all consumables.
3. Scrap the machine according to the local legislation.
Version 2016-2
Possible cause
The capacitive sensor is set too low. Adjust the capacitive sensor higher.
The substrate slide is set too low.
User Manual Javo Traytopper
Action / Solution
Attention! Too much spreading material
will possibly slip the belt.
Adjust the slide higher.
Set the spreading belt faster.
Set the tray conveyor slower.
General rule: fine spreading material 2 cm
free passage, stones at 4 cm free passage
17

Advertisement

Table of Contents
loading

Table of Contents