• Carefully pull the fuser up and out of the printer by the handle (a).
• Place the fuser on a pre-determined surface that will not be damaged by heat.
• When replacing the fuser, the two locating lugs (c) will face towards you. You should also
be able to read the yellow caution label. When oriented correctly, the fuser will slide
readily into place.
• Latch the fuser back into place using the two blue latches (b).
• Close the printer top and press down firmly on both sides to ensure that it is shut properly.
Fuser Replacement
Fuser Positioning
- 52 -
NeuraLabel 600e Printing Guide