NeuraLabel 600e Printing Manual page 30

• Set the Adjust Mode to No Adjustment, telling the printer not to look for marks or gaps.
• Enter a Footer Margin, which is the gap between the labels, for example, 0.25.
• The Start and Cut should be set to 0 since this is not a die-cut label configuration.
• Click the Add>> button to create the page.
• If you make changes, you must click the Modify button to save the changes.
• Click OK to close the panel(s) when settings or changes are complete. Remember, you
must click the Add>> button to create a page and the Modify button to change the
selected page. Clicking OK is not sufficient.
0.25 for example
0
0
Configuring the Driver for Label Press
All other options should remain unchanged.
WARNING: Entering a negative value or a value other than 0 in the Start or Cut
value in No Adjustment mode may result in a printing error.
No Adjustment
NeuraLabel 600e Printing Guide
- 24 -