NeuraLabel 600e Printing Manual page 28

o To move the image down the page, adjust to a larger number.
o To move the image up the page, adjust to a smaller number.
• Cut is 0.70 for NeuraLabel marked media. This allows the printer to stop in the correct
location for cutting in the media gap, providing a precision cut based on media marks.
o The CFA controls the exact cut using the cut marks.
o This value will be different (cut = 0.0) for media without marks. Media without
marks will cut in the middle of the label, not in the gap between labels.
o To move the cut down the page, adjust to a larger number.
o To move the cut up the page, adjust to a smaller number.
• Enable Cut must be checked.
• Adjust Mode must be set to Adjustable.
• Cut Mode must be set to Stop and Cut.
• Click the Add>> button to create this super-long label page, and it will be added to the list.
• If you make changes, you must click the Modify button to save the changes.
• Click OK to close the panel(s) when settings or changes are complete.
NOTE: You must click the Add>> button to create a page and the Modify button to change
the selected page. Then click OK; otherwise your work will not be saved.
WARNING: Selecting Adjustable causes the printer to look for the mark or gap
signal from the CFA. Using this mode with unmarked media may result in a
printing error.
NeuraLabel 600e Printing Guide
- 22 -