Table of Contents
Advertisement
MANUAL TRANSMISSION
Manual Transmission Mode
Note: Program switch #2 on control unit must be in "ON" position.
In order to start a Manual Transmission equipped vehicle:
Manual Transmission Reservation Mode must be enables each time.
Manual Transmission Reservation Mode.
1. Leave the Ignition Key in the "On" position (Car is still running).
2. Press and hold the brake pedal, then press & release button #4.
The system will respond with 1 siren/horn chirp & light flash.
3. Turn the Ignition Key "Off" - the vehicle should stay running.
4. Within 20 seconds open and close door (Note: The door switch input must
be hooked up).
5. Within 20 seconds of the door closing, press button #1, the doors will lock
and the vehicle will shut "off".
6. The vehicle can now be remote started by pressing button #3.
Note: If a door is opened, the brake is pressed or the ignition turned "on", the
vehicle will exit Reservation Mode.
Note: For increased protection, a Radar Sensor is recommended to protect
anyone from getting near the gearshift if the vehicle is a convertible or if
a window is opened.
Connect the Radar Sensor through relay to the Green/White wire hood
safety switch input
OTHER FEATURES
OTHER FEATURES
Transmitter Service Mode
In this mode, the vehicle will only Lock, Unlock, Panic and Trunk Release.
1. Press & release button #3 quickly.
2. Within 2 seconds press and hold down button #1 for 5 seconds.
The system will respond with 5 siren/horn chirps and flashes.
To disable Transmitter Service Mode
Repeat steps 1& 2 indicated above.
The system will respond with 2 siren/horn chirps and flashes to confirm that
Transmitter Service Mode is disabled.
Shutdown Auto lock
Once the system cycles through its Programmed Run Time, after 5 seconds, the
system will automatically lock doors.
Instant Start Input
The system is equipped with a Instant Start Input, which is used for optional
starting triggers i.e.: Phone Start systems, Digital Timers or Low Temperature
Sensors. The Instant Start can also be used to test the starting portion of the
Remote Starter System.
Note: A momentary pulse of less than 2 seconds on the input lead will activate
the Remote Start Sequence..
Advertisement
Table of Contents
