Table of Contents
Advertisement
PROGRAMMING MODES - Tach Detection
VOLTAGE SENSE MODE (SYSTEM DEFAULT
Note: Ensure that program switch #1 is in the "Off" position.
The recommended setting is Voltage Sense Mode. This method requires no additional wiring.
Note: In Voltage Sense Mode, do NOT connect the Black/White Tach Sense Wire.
If voltage Sense Mode does not start the car properly, proceed into:
TACH SENSE / TACH LEANING MODE
Note: Ensure that program switch #1 is in the "Off" position.
In this mode the system will sense and/or learn the tach pulses from the vehicle.
Connect the Black/white Tach wire and follow T ach Learning Procedure. (See Below).
If Tach Sense/Learn Mode does not start the car properly, proceed into:
TACHLESS TIMER MODE
Note: Ensure that program switch #1 is in the "Off" position.
In this mode the starter will stop cranking after a pre-determined crank time. (See Below).
If Tachless Timer Mode does not start the car properly, proceed into:
ALTENATOR SENSING MODE
Note: Ensure that program switch #1 is in the "On" position.
In this mode the system will sense the change in voltage from Ground to +12 VDC when the
vehicle has started and subsequently stop cranking. Locate wire on alternator that goes from
ground to 12V+ when vehicle has started
FEATURE 1 - TACH SENSING METHOD
1. Enter in "Program Mode" (See
1. Open the hood. 2. Turn the Ignition Key "On/Off", "On/Off", "On".3. Press & Release the Valet button on the antenna.).
(
2. Press & release button #1- #2- #1- #2 to select which Sensing Method will be used.
#1- #2- #1- #2
1 Time
2 Times
3 Times (Default)
TO TACH LEARN
TO TACH LEARN
1. Switch #1 must be in the "Off" position.
2. Enter into Feature 1 Program Mode and select Tach Learning.
3. Start the vehicle with the key and leave the key "On". Do not shut "Off" the ignition.
The system will confirm it has learned the Tach Pulses by turning the lights "On" and then
flashing the lights and chirping the siren/horn 3 times.
Enter program Mode
)
Output
Tach Learning (See Below)
Tachless Timer Mode
Voltage Sensing
)
Confirmation
1 flash and chirp
2 flashes and chirps
3 flashes and chirps
Advertisement
Table of Contents
