Ultra Start Pro Series Installation Manual page 3

BASIC INSTALLATION - QUICK START
-
STEP 1
6 PIN POWER CONNECTOR - Connect the following:
WIRE FUNCTION
RED-1 Main Power
RED-2 Main Power
BLUE Ignition
YELLOW Starter
GREEN Accessory
BLACK System Ground
14 PIN CONNECTOR - Connect the following:
WIRE FUNCTION
White Parking Lights
Green/White Hood Pin Safety
Brake Pedal Safety Shut Down
STEP 2 -
Plug the connectors into the unit
Plug the 6 Pin Connector into the Remote Starter module then plug the 14 Pin
and any other connectors into unit.
***Make sure that Ignition Key is in the OFF position****
STEP 3- Remote Start Vehicle
Press and hold the Start button for 3 seconds to start vehicle and confirm vehicle
starts correctly and heater comes on.
If vehicle does not does not start correctly check the following:
Correct Ignition
Correct Starter
Factory Security
Connect Tach wire and follow tach learning procedures.
Your Standard Installation is Now Complete!!
The following connection is necessary for installation on vehicles with manual transmissions.
MANUAL TRANSMISSION
Green Door Trigger
OR
Violet Door Trigger
NOTE : Place dip switch #2 in the "ON" position for all manual
Transmission installations
The following wires must be connected
Input
Input
Output
Output
Output
Input
Output
Input
Input
Input
Input
CONNECT TO ON VEHICLE
(+) Constant 12V (+) at Ignition Harness
(+) Constant 12V (+) at Ignition Harness
(+) Main Ignition (+) at Ignition Harness
(+) Starter Wire (+) at Ignition Harness
(+) heater wire
(-) Ground on Vehicle (-)
CONNECT TO ON VEHICLE
(+) 12v(+) Parking Lights
(-) Hood Pin Switch (-) when hood open
(+) 12v when brake pedal is pressed
(-)
Connect to Door Pin Switch (-) when door is open
(+)
Connect to Door Pin Switch (+) when door is open
S
(+) at Ignition Harness