Table of Contents
Advertisement
PROGRAMMING - Option Settings
Feature 2 - Door Lock Timing - Default: 0.75 Seconds.
1. Enter in "Program Mode" (See
(1. Open the hood. 2. Turn the Ignition Key "On/Off", "On/Off", "On".3. Press & Release the Valet button on the antenna.).
2. Press & release button #1- #3- #1 to select which Door Lock timing will be used.
#1- #3- #1
Output
1 Time
3 second Pulses
2 Times
0.75 Sec.Pulses & Double Unlock Pulses 2 flashes and chirps
3 Times (Default)
0.75 sec.Pulses & Double Unlock Pulses 3 flashes and chirps
Feature 3 - Gas / Diesel Engine Mode - Default: Gas Engine Mode
1. Enter into "Program Mode" (See
(1. Open the hood. 2. Turn the Ignition Key "On/Off", "On/Off", "On".3. Press & Release the Valet button on the antenna.).
2. Press & release button #3- #1- #2 to select which Engine Type Mode will be used.
#3- #1- #2
1 Time
Diesel Timer Mode
2 Times
3 Times (Default)
Gas Vehicle Mode
Feature 4 - Ignition Auto Lock / Unlock
1. Enter into "Program Mode" (See
(1. Open the hood. 2. Turn the Ignition Key "On/Off", "On/Off", "On".3. Press & Release the Valet button on the antenna.)
2. Press & release buttons #1- #3- #2 to select which Ignition Auto-Lock will be used.
#1- #3- #2
1 Time
2 Times
3 Times (Default)
Feature 5 - Gm Factory Re- Arm Mode/Dome Light mode
Default: Dome-light Mode)
1. Enter into "Program Mode" (See
(1. Open the hood. 2. Turn the Ignition Key "On/Off", "On/Off", "On".3. Press & Release the Valet button on the antenna.)
2. Press & release buttons #1- #3- #3 to select which Output will be used.
#1- #3- #3
1 Time
2 times
Note: In GM Rearm Mode, when the vehicle is running under remote control and shuts
down at end of the run time, or is turned off by remote, the Dome-light Output will turn "On"
and will stay "On" until 2 seconds after the door locks are locked, then shut "Off". This will
arm Factory GM Alarm.
Feature - 6 Chirp Delete/Chirp Enabled-
1. Enter into "Program Mode" (See
(1. Open the hood. 2. Turn the Ignition Key "On/Off", "On/Off", "On".3. Press & Release the Valet button on the antenna.)
2. Press & release buttons #2- #1- #1 to select if Chirp Delete is required.
#2- #1- #1
1 Time
2 Time
Enter program Mode
Enter program Mode
Engine Type/Mode
Diesel Glow Plug Input(requires module)
Enter program Mode
Output
Disabled
Ignition Auto-Lock only, no Unlock
Ignition Auto-Lock/Unlock "On"
Enter program Mode
Output
GM Re-Arm Mode
Normal Dome-light Mode
Enter program Mode
Chirp Status
Chirp Deleted
Chirp Enabled
)
Confirmation
1 flash and chirp
)
Confirmation
1 flash and chirp
2 flashes and chirps
3 flashes ans chirps
)
Confirmation
1 flash and chirp
2 flashes and chirps
3 flashes and chirps
)
Confirmation
1 flash and chirp
2 flashes and chirps
)
Confirmation
1 flash and chirp
2 flashes and chirps.
Advertisement
Table of Contents
